Question 1

What is the command 'asg diag' used for?

Options :

A : Asg diag used for system diagnostics on Chassis only. It does not exist on Maestro

B : Asg diag is used for system backup

C : Asg diag is used for system diagnostics

D : Asg diag is used for creating traffic flow diagrams

Answer: C

Question 2

What type of license is required for an MHO?

Options :

A : The MHO requires a NGTP license.

B : The MHO requires a VSX license.

C : The MHO does not require a license.

D : A license is needed for each attached SGM.

Answer: C

Question 3

While looking at your system's correction statistics, you notice you have a correction rate approaching 100 percent. Is this a problem?

Options :

A : A correction rate above 90 percent indicates a need to disable Layer 4 Distribution.

B :

A correction rate approaching 100 percent of all connections is unusual. This is a cause for concern because the SGMs may fail to process traffic.

C : If correction rates are higher than 80 percent, latency is expected.

D :

In some scenarios, a correction rate approaching 100 percent of all connections is not unusual. This is not usually a cause for concern as the correction mechanism is fast and efficient.

Answer: B

Question 4

What is the purpose of interface bonding?

Options :

A : A bond interface can be configured for high availability redundancy.

B : A bond interface is used for passing synchronization traffic between the SGMs.

C :

For load sharing which increases connection throughput above that which is possible using one physical interface.

D :

A bond interface can be configured for high availability redundancy or for load sharing which increases connection throughput above that which is possible using one physical interface.

Answer: D

Question 5

Which blade configuration files should be backed up on the SG if upgrading from R80.30SP or earlier?

Options :

A : IPS configuration files

B : fwkern.conf files.

C : VPN configuration files

D : Mobile Access configuration files.

Answer: A