Question 1

A customer is starting an Advanced Meter Infrastructure (AMI) roll-out initiative and they plan to replace their legacy scalar time-of-use (TOU) meters with smart meters. They want customer information system (CIS) to continue to bill for the same TOU periods and they do not want to change the CIS rates.In which THREE ways can you configure Meter Data Management (MDM) to support this requirement?

Options :

A : Write a custom algorithm to determine the proper rate.

B : Add an extendable lookup value containing the new device configuration type and the new usage calculation group.

C : Add the TOU mapping rule to the existing usage calculation group.

D : Add a new usage calculation group with a TOU mapping rule.

E : Set up the new usage calculation group to be identified dynamically by plug-in logic supplied on the usage subscription-s type.

Answer: A,B,C

Question 2

Which THREE tasks would you perform when configuring the application to generate service investigative orders for revenue protection?

Options :

A : Tune the AI engine to look for theft by using theft algorithms. Configure case management.

B : Set up VEE rules to look for low usage.

C : Configure service task type to look far Validation, Estimation, and Editing (VEE) exceptions, device events, and failed commands.

D : Import device events related to theft.

Answer: B,C,D

Question 3

Initial measurement data (IMD) is imported into Meter Data Management (MDM) and can be viewed through the Measuring Component portal, but is not in the "Final" measurement status. What has the IMD passed in this case?

Options :

A : Critical validation

B : Multiplier check validation

C : Critical validation, high/low check validation, and sum check validation

D : High/low check validation

E : Sum check validation

Answer: A

Question 4

Dynamic aggregation uses dynamic queries for aggregation processes. These dynamic queries are based on the configuration of administrative data. Which THREE statements are true about the dynamic aggregation main components?

Options :

A : Measuring Component Sets define the dimensions and criteria by which aggregation is performed.

B : Aggregation Ordering Sets define the ordering of a series of related aggregations and the schedule of aggregation.

C : Measuring Components, also known as aggregator MCs, represent "buckets" or unique combinations of dimension values.

D : Aggregation Measuring Component Types define the most important properties of aggregation measuring components used for storing aggregated data.

E : Data sources store project-provided SQL for getting data.

Answer: A,C

Question 5

A time-of-use (TOU) template's interval size controls the values allowed as start and end times. A template can be used to generate TOU data for TOU maps whose seconds per interval (SPI) is divisible by the template's SPI. For what can you use a 60-minute template?

Options :

A : To only generate TOU data for 30-minute TOU maps.

B : To generate TOU data for 6G-, 15-, and 5-minute TOU maps.

C : To generate TOU data for 120-minute TOU maps.

D : To only generate TOU data for minute TOU maps.

E : To generate TOU data for 120-minute and 1440-minute TOU maps.

Answer: D