Question 1

Which node automatically assumes the active role when peers boot simultaneously and their health scores are equivalent in a High Availability (HA) scenario?

Options :

A : the node with the highest wancom IP address

B : the node that is configuredas secondary

C : the node that had the role of active last

D : the node with the lowest wancom IP address

E : the node with the highest round-robin score

Answer: D

Question 2

What is thedrawback of configuring Policy-Based Realm Bridging (PBRB) without the assistance of Header Manipulation Rules (HMRs)?

Options :

A : Topology hiding is incomplete.

B : The configuration requires a home realm to be defined, which can make privacy harder to achieve.

C : The configuration requires you to enable SIP-NAT bridging, which is complex.

D : The architecture is simple, and really designed for lab environments.

E : The performance is poor relative to other models

Answer: C

Question 3

After configuring Header Manipulation Rules (HMRs) for topology hiding, your subsequent testing shows that the manipulation is not takingeffect. Identify two causes for this (Choose two.)

Options :

A : You have not configured the out-manipulationid parameter of the sip-interface configuration element.

B : You have not enabled policy-based realm-bridging

C : The value of the name parameter in the header-rule configuration element is different than the value of the out-manipulationid parameter in the sip-interface configuration element.

D : The value of the match-val-type parameter is not written correctly

E : The home-proxy-address value does not matchthe $LOCAL_IP value in the new-value parameter.

Answer: A,E

Question 4

Which statement is true when SNMP access is enabled to the Session Border Controller?

Options :

A : The default community strings are acme and packet.

B : The default community stringsare public and private.

C : Community strings are in passive mode.

D : There are no default community strings.

E : Only one trap receiver can be configured.

Answer: B

Question 5

You are configuring a network interface to enable the Session Border Controller to use the interface for signaling and media. Identify two valid configuration steps for supporting VLAN 12 (Choose two.)

Options :

A : Navigate to the network-interface configuration element and set the sub-port-id parameter to 12.

B : Navigate to the network-interface configuration element and set the sub-port-id parameter to 0.

C : Navigate to the phy-interface configuration element and configure the hip-id parameter.

D : Navigate to the phy-interface configuration element and configure the pri-utility-address parameter.

E : Navigate to the network-interface configuration element and configure the name parameter.

Answer: A,C