Question 1

An administrator is adding a new ESXi host to an existing vSphere cluster. When selecting the cluster, the administrator is unable to use the Cluster Quickstart workflow to add and configure the additional host.

What could be the root cause of this issue?

Options :

A : The administrator has previously dismissed the Cluster Quickstart workflow.

B : The administrator must manually add the host to the cluster before using the Cluster Quickstart workflow.

C : The administrator has not been assigned the required permissions to use the Cluster Quickstart workflow.

D : The administrator must enable the Cluster Quickstart workflow option in VMware vCenter.

Answer: A

Question 2

You are remediating a group of ESXi hosts using Lifecycle Manager. In your configuration, specific VMs must run on certain hosts. This means that during the remediation process, those VMs cannot be relocated to another host. Which remediation option can be used to minimize the downtime of these VMs?

Options :

A : Suspend to memory / Quick boot

B : Do not change power state

C : Suspend to disk / Quick boot

D : Disable HA admission control

Answer: A

Question 3

Refer to the exhibit.

After removing an ESXi host from a cluster for maintenance, a number of virtual machines have encountered the warning seen in the exhibit.

After re-adding the ESXi, the issue is resolved.

Which step should the administrator take to move the triggered alarm to its normal state?

Options :

A : Ignore

B : Acknowledge

C : Disable

D : Reset to Green

Answer: D

Question 4

Which of the following are valid requirements to enable Storage I/O Control on a datastore? (Choose two.)

Options :

A : Raw Device Mappings in Physical mode are supported

B : Datastores with multiple extents are not supported

C : NFS storage is not supported

D : The datastore must be managed by a single vCenter

Answer: B,D

Question 5

An administrator is asked to segregate virtual machine (VM) traffic by VLAN on a vSphere standard switch.

The following requirements must be met:

• VLAN ID on the switch port group must be 4095.

• VLAN tagging must be done at the VM level.

Which tagging mode is required?

Options :

A : External Switch Tagging (EST)

B : None

C : Virtual Guest Tagging (VGT)

D : Virtual Switch Tagging (VST)

Answer: C