Question 1

How does the Traceflow tool identify issues in a network?

Options :

A :

Compares the management plane configuration states containing control plane traffic and error reporting from transport node agents.

B :

Compares intended network state in the control plane with Tunnel End Point (TEP) keepalives in the data plane.

C : Injects ICMP traffic into the data plane and observes the results in the control plane.

D : Injects synthetic traffic into the data plane and observes the results in the control plane.

Answer: D

Question 2

Which two built-in VMware tools will help Identify the cause of packet loss on VLAN Segments? (Choose two.)

Options :

A : Flow Monitoring

B : Packet Capture

C : Live Flow

D : Activity Monitoring

E : Traceflow

Answer: B,E

Question 3

An NSX administrator is creating a Tier-1 Gateway configured In Active-Standby High Availability Mode. In the event of node failure, the failover policy should not allow the original tailed node to become the Active node upon recovery. Which failover policy meets this requirement?

Options :

A : Non-Preemptive

B : Preemptive

C : Enable Preemptive

D : Disable Preemptive

Answer: A

Question 4

Which two are supported by L2 VPN clients? (Choose two.)

Options :

A : NSX for vSphere Edge

B : 3rd party Hardware VPN Device

C : NSX Autonomous Edge

D : NSX Edge

Answer: A,D

Question 5

What needs to be configured on a Tler-0 Gateway lo make NSX Edge Services available to a VM on a VLAN-backed logical switch?

Options :

A : Downlink Interface

B : VLAN Uplink

C : Loopback Router Port

D : Service Interface

Answer: B