Question 1

An engineer uses Postman and YANG to configure a router with:

OSPF process ID 200

network 172.16.10.128/26 enabled for Area 0

Which get-config reply verifies that the model set was designed correctly?

Options :

A : Text, letter Description automatically generated

B : Graphical user interface, text, letter, email Description automatically generated

C : Text, letter Description automatically generated

D : Text, letter Description automatically generated

Answer: A

Question 2

Refer to the exhibit. An architect is designing a network that requires route redistribution. The design must prevent route feedback and the creation of routing loops. The OSPF domain is using default metrics, and the IS-IS domain is using narrow metrics. Which solution must the architect select?

Options :

A : Change the IS-IS administrative distance to 105.

B : Change the OSPF area to a nonbackbone stub area

C : Use route filtering with an ACL or prefix list.

D : Use route tagging with a route map.

Answer: D

Question 3

Which control plane protocol is responsible for ElD-to-RLOC mapping concerning SO-Access Architecture?

Options :

A : GBAC

B : LISP

C : CEF

D : VXLAN

Answer: B

Question 4

Refer to the exhibit. A customer is planning to onboard three new VPN partner connections in the data center. The new subnets must not overlap with the existing data center network, and the subnet size must not be bigger than necessary. The customer dedicated 10.1.8.0/21 for this design. Ho1// must the subnets be divided to meet these requirements?

Options :

A :

B :

C :

D :

Answer: B

Question 5

A network engineer must design an MSDP multicast solution to provide RP resilience in a network with two separate domains. Also, multicast sources and receivers must register with the local RP. Which solution must the engineer choose?

Options :

A : Configure the RP has value to 0, and traffic will route to the closest RP

B : Configure the RP loopback interface with the same IP address/32, and traffic will route to the closest RP

C : Configure the RP group ranges to split the multicast traffic, and traffic will route to the longest match

D : Configure the RP priority with the same value, and traffic will route to the closest RP

Answer: B