Question 1

When creating a subnet within a bridge domain, which configuration option is used to specify the network visibility of the subnet?

Options :

A : limit IP learning to subnet

B : scope

C : gateway IP

D : subnet control

Answer: B

Question 2

An engineer wants to configure Cisco ACI switches to use authenticated ZMQ when communicating with the proxy spine. Which configuration allows MD5 ZMQ messages only?

Options :

A : COOP Group policy in strict mode

B : IS-IS password using MD5

C : BGP password using MD5

D : COOP Group policy in compatible mode

Answer: A

Question 3

An engineer created two interface protocol policies called Pol_CDP40275332 and Pol_LLDP46783451. The policies must be used together in a single policy. Which ACI object must be used?

Options :

A : interface policy group

B : switch policy group

C : switch profile

D : interface profile

Answer: A

Question 4

An engineer must advertise a bridge domain subnet out of the ACI fabric to an OSPF neighbor. Which two configuration steps are required? (Choose two.)

Options :

A : Add External Subnet for External EPG flag under External EPG

B : Configure Subnet scope to Advertised Externally

C : Configure the Subnet under the EPG level

D : Create Route Control Profile with the export direction under External EPG

E : Add L3Out profile to the bridge domain using Associated L3Outs section

Answer: B,E

Question 5

An engineer must adjust the time on a Cisco ACI fabric. The implementation must use a single external time server and the APIC management interfaces for the communication. Which action accomplishes this goal?

Options :

A : Enable the Date and Time offset state in the system settings.

B : Set the NTP provider minimum polling interval to 1.

C : Set the NTP provider in default Date and Time policy.

D : Create a contract in the management tenant to allow UDP port 123.

Answer: C