Question 1

A customer wants to provide wireless access to contractors using a guest portal on Cisco ISE. The portal is also used by employees. A solution is implemented, but contractors receive a certificate error when they attempt to access the portal. Employees can access the portal without any errors. Which change must be implemented to allow the contractors and employees to access the portal.

Options :

A : Install a trusted third-party certificate on the Cisco ISE.

B : Install an Internal CA signed certificate on the contractor devices

C : Install an internal CA signed certificate on the Cisco ISE

D : install a trusted third-party certificate on the contractor devices.

Answer: B

Question 2

What is one difference between the RIB and the FIB?

Options :

A : The RIB works at the data plane, and the FIB works at the control plane.

B : The RIB is known as the CEF table, and the FIB is known as the routing table.

C :

The FIB contains routing prefixes, and the RIB contains the Layer 2 and Layer 3 information necessary to make a forwarding decision.

D :

The RIB keeps all routing information received from peers, and the FIB keeps the minimum information necessary to make a forwarding decision.

Answer: D

Question 3

Refer to the exhibit. A network engineer issues the debug command while troubleshooting a network issue. What does the output confirm?

Options :

A : ACL100 is tracking ICMP traffic from 1.1.1.1 destined for 10.1.1.1.

B : ACL100 is tracking all traffic from 10.1.1.1 destined far 1.1.

C : ACL100 is tracking ICMP traffic from 10.1.1.1 destined for 11.1.1

D : ACL100 is tracking ICMP traffic from Serial 1/0 destined for Serial3/0.

Answer: B

Question 4

What is a client who is running 802.1x for authentication reffered to as?

Options :

A : supplicant

B : NAC device

C : authenticator

D : policy enforcement point

Answer: A

Question 5

Refer tolheexhibit An engineer must configure HSRP for VLAN 1000 on SW2 The secondary switchmusíimmediately lake over the rote of active router if the interlink with the primary switch fails Which command set completes this task?

Options :

A :

B :

C :

D :

Answer: D