Question 1

Click on the exhibit below.

In the following diagram, traffic ingressing on SAP 1/2/3:1 will be passed to the layer-2 DPI device for inspection based on a filter policy applied to the ingress of the SAP. What feature should be enabled on SAP 1/2/1:100 and SAP 1/2/2:100 to ensure that incorrect information is not populated in the FDB of VPLS 1?

Options :

A : Learning should be disabled on both SAPs connected to the DPI device to prevent FDB instability

B : A MAC filter should be applied to both SAPs connected to the DPI to limit MAC learning on the port

C : An IP filter should be applied to both SAPs connected to the DPI to prevent FDB instability

D : The SAPs connected to the DPI should be configured with the "discard-unknown" feature to limit MAC learning on the port

Answer: A

Question 2

How is the Primary Bridge chosen in a VPLS?

Options :

A : The PE devices participating in the VPLS mesh run a separate Spanning Tree instance in the Core. The Primary Bridge is the Root Bridge for the VPLS mesh.

B : The PE devices participating in the VPLS mesh determine which bridge is closest to Root Bridge. This bridge becomes the Primary Bridge.

C : The PE devices participating in the VPLS mesh determine which bridge has the lowest bridge-id. This bridge becomes the Primary Bridge.

D : The PE devices participating in the VPLS mesh determine which bridge is the Root Bridge. This becomes the Primary Bridge.

Answer: B

Question 3

What configuration is required on the CE device when using MC-LAG?

Options :

A : The CE must be configured with an MC-LAG to both PE devices.

B : The CE must be configured with LACP in active mode.

C : There is no configuration required on the CE.

D : The CE must be an Alcatel-Lucent 7750 SR.

Answer: B

Question 4

How is it possible for multiple services to be carried over the same MPLS LSPs?

Options :

A : Multiple SDPs must be configured and bound to the LSPs for this to be possible.

B : It is not possible to carry multiple services over the same MPLS LSPs.

C : A vc-label is signaled per service.

D : The vc-id is part of the data plane and maps the traffic to the appropriate service.

Answer: A

Question 5

Click on the exhibit below.

Assume PE-B expects avian tag as part of the RFC 4762 (Martini) encapsulation. How must PE-A be configured?

Options :

A : The port that the SAP belongs to must have the correct ether type configured.

B : The SAP must be configured with the right VLAN tag

C : The SDP VC type must be configured as type VLAN and the correct vlan-vc-tag must be specified

D : All of the above.

Answer: C