Question 1

What are the relevant use cases for helper key figures?Note: There are 2 correct answers to this questions.

Options :

A : Used at any level of calculation level except the Request Level

B : Used when you have more than three inputs at different planning levels in one calculation

C : Used by end-users in planning views to help visualize cross-period calculations

D : Used to break down a large calculation into manageable subcalculations

Answer: B,D

Question 2

You are adding a value-based filter to a planning view. Which of the following conditions apply? Note: There are 3 correct Answers to this question.

Options :

A : The alerts dashboard is not available if a value-based filter is set for the open planning view.

B : These filters are always applied based on the values stored in the database.

C : You can only apply one value-based filter per planning view.

D : These filters can be used together with attribute totals in the same planning view.

E : You can add (or delete) planning objects to a planning view after these filters are applied.

Answer: A,B,C

Question 3

You create an S&OP operator for heuristics on an SAP IBP project. What must you enable for the S&OP operator that is specifically relevant for subnetworks?

Options :

A : Compute Expected Supply parameter

B : Balance Receipts parameter

C : Normalize Quotas parameter

D : Supply propagation

Answer: A

Question 4

While modeling for a large machine with high capital needs, you need it to run cost effectively with minimum utilization, even if it means producing more than demand. Which solution would apply to this scenario? Note: There are 2 correct Answers to this question.

Options :

A : Capacity leveling will be possible for production and storage resources.

B : Excess stock can be generated and will need to be staged in an overflow warehouse.

C : Enough demands can be pulled forward and pull production will occur.

D : Balance can be achieved between excessive prebuild and minimum utilization by incorporating violation costs.

Answer: C,D

Question 5

What are some of the prerequisites for configuring a planning area that results in a successful consistency check? Note: There are 2 correct Answers to this question

Options :

A : Configure at most two input key figures on the same planning level in a key figure calculation.

B : Assign the compound master data type and its component master data types.

C : Specify a planning horizon in the planning area for each level of the assigned time profile.

D : Configure at least one calculated key figure for the planning area.

Answer: B,C