Question 1

What does setting the alert threshold to 0 (zero) do when configuring replication rules?

Options :

A : Disables all alerts for any missed RPO cycles.

B : Generates an alert if the data saved during the RPO cycle exceeds 20% of the storage object capacity

C : Enables alerts if the RPO cycle was missed for three consecutive cycles.

D : Generates an alert if the synchronization time exceeds the RPO.

Answer: D

Question 2

A PowerStore T administrator discovers that only one port on each node is active and passing traffic. The other port is healthy and online, but total bandwidth is only half of what the customer expects. Which two actions could resolve the issue? (Choose two.)

Options :

A : Configure Dynamic LAG

B : Configure VLT

C : Configure RSTP

D : Configure LACP

Answer: A,D

Question 3

An administrator is asked to create NVMe-vVol host in PowerStore. Which requirement must be met to complete the task?

Options :

A : The host must be using the ESXi operating system

B : NVMe-vVol must be created on internal hosts

C : Two appliances must be available to allow NVMe-vVol migration

D : Switches must support NVMe/TCP protocol

Answer: A

Question 4

While trying to add iSCSI hosts to a host group, some of the hosts are not showing up within the Add Host Group list. What is causing this?

Options :

A : Missing hosts have mapped volumes

B : iSCSI CHAP is disabled

C : Storage network is not configured

D : Missing hosts are marked for iSCSI and FC

Answer: A

Question 5

What is the maximum number of supported replication and snapshot rules in a protection policy?

Options :

A : One snapshot rule and four replication rules

B : One snapshot rule and one replication rule

C : Four snapshot rules and one replication rule

D : Four snapshot rules and four replication rules

Answer: C