Question 1

When reviewing storage group compliance for a specific storage group, you notice that the weighted response time for the storage group over the last four hours is compliant Upon further research, you see that the weighted response time for the last two weeks does not meet the defined response time for the assigned service level. What is the overall compliance status for the storage group?

Options :

A : Stable

B : Marginal

C : Non-compliant

D : Critical

Answer: C

Question 2

If a data reduction hardware I/O module fails, what happens to incoming data?

Options :

A : Data is written to disk without any data reduction

B : Software-based reduction is used to reduce data

C : Incoming data is held in cache until the failed hardware I/O module is replaced

D : Hardware I/O module in the partner director within the engine is used to reduce data

Answer: B

Question 3

What are the two configuration rules that apply to SRDF groups and connections during NonDisruptive Migrations'?

Options :

A : The source and target arrays are at most one hop away from the control host

B : Two DM RDF groups are created per SG migration session

C : RF and CK ports are supported, with RF ports being selected if both types are available

D : A single array cannot have multiple DM RDF groups

E : DM RDF groups are configured with a minimum of one path

Answer: A,E

Question 4

Which SYMCLI command can be used to create a new TDEV and assign it to a Storage Group in one step?

Options :

A : symdev

B : symsg

C : symcfg

D : symaccess

Answer: A

Question 5

When setting Host I/O Limits on a Storage Group, what are the available dynamic I/O distribution modes?

Options :

A : Never, OnFailure. and Always

B : Balanced Always, and OnFailure

C : Never, Balanced, and Always

D : Balanced, OnFailure. and Never

Answer: C