Question 1

Refer to the exhibit.The NOC team connects to the FortiGate GUI with the NOC_Access admin profile. They request that their GUI sessions do not disconnect too early during inactivity. What must the administrator configure to answer this specific request from the NOC team?

Options :

A : Move NOC_Access to the top of the list to ensure all profile settings take effect.

B : Increase the offline value of the Override Idle Timeout parameter in the NOC_Access admin profile.

C : Ensure that all NOC_Access users are assigned the super_admin role to guarantee access

D : Increase the admintimeout value under config system accprofile NOC_Access.

Answer: D

Question 2

Which three statements about SD-WAN performance SLAs are true? (Choose three.)

Options :

A : They rely on session loss and jitter.

B : They can be measured actively or passively

C : They are applied in a SD-WAN rule lowest cost strategy

D : They monitor the state of the FortiGate device.

E : All the SLAtargets can be configured.

Answer: A,B,E

Question 3

You have configured the below commands on a FortiGate.What would be the impact of this configuration on FortiGate?

Options :

A : FortiGate will enable strict RPF on ail its interfaces and port1 will be enable for asymmetric routing.

B : FortiGate will enable strict RPF on all its interfaces and port1 will be exempted from RPF checks.

C : Port1 will be enabled with flexible RPF, and all other interfaces will be enabled for strict RPF

D : The global configuration will take precedence and FortiGate will enable strict RPF on all interfaces.

Answer: B

Question 4

What are three key routing principles in SD-WAN? (Choose three.)

Options :

A : By default. SD-WAN rules are skipped if the included SD-WAN members do not have a valid route to the destination.

B : SD-WAN rules have precedence over any other type of routes.

C : Regular policy routes have precedence over SD-WAN rules.

D : By default. SD-WAN rules are skipped if only one route to the destination is available.

E : By default. SD-WAN rules are skipped if the best route to the destination is not an SD-WAN member.

Answer: A,B,E

Question 5

When configuring firewall policies which of the following is true regarding the policy ID?

Options :

A : It is mandatory to provide a policy ID while creating a firewall policy regardless of GUI or CLI.

B : A firewall policy ID identifies the order of policy execution in firewall policies.

C : You can create a policy in CLI with policy ID 0.

D : A policy ID cannot be edited once a policy is created.

Answer: D