Question 1

The local OSPF router is unable to establish adjacency with a peer. Which two things should the administrator do to troubleshoot the issue? (Choose two.)

Options :

A : Check whether TCP port 179 is blocked.

B : Check if there is an active static route to the peer.

C : Check whether both peers have an IP address within the same subnet.

D : Check if IP protocol 89 is blocked.

Answer: C,D

Question 2

Refer to the exhibit, which shows the output of a debug command.

Which two statements about the output are true? (Choose two.)

Options :

A : The interlace is part of the OSPF backbone area.

B : There are a total of five OSPF routers attached to the vorz4 network segment

C : One of the neighbors has a router ID of 0.0.0.4.

D : In the network connected to port4, two OSPF routers are down.

Answer: A,D

Question 3

Refer to the exhibit, which shows partial outputs from two routing debug commands.

Which change must an administrator make on FortiGate to route web traffic from internal users to the internet, using ECMP?

Options :

A : Set snat-route-change to enable.

B : Set the priority of the static default route using port2 to 1.

C : Set preserve-session-route to enable.

D : Set the priority of the static default route using port1 to 10.

Answer: D

Question 4

Which statement about protocol options is true?

Options :

A :

Protocol options allow administrators to configure a maximum number of sessions for each configured protocol.

B :

Protocol options give administrators a streamlined method to instruct FortiGate to block all sessions corresponding to disabled protocols.

C :

Protocol options allow administrators to configure the Any setting for all enabled protocols, which provides the most efficient use of system resources.

D :

Protocol options allow administrators to configure which Layer 4 port numbers map to upper-layer protocols, such as HTTP, SMTP, FTP, and so on.

Answer: D

Question 5

Refer to the exhibit, which shows the port1 interface configuration on FortiGate and partial session information for ICMP traffic.

What happens to the session information if a routing change occurs that affects this session?

Options :

A : Only the interface and gateway information for dev=7 will be removed.

B :

The session information will not change unless the current route has been removed from the routing table.

C : The session will be flagged as dirty but no route lookups will be performed.

D : Sessions involving port7 or port19 will not have their routing information flushed.

Answer: B