Question 1

What are two reasons you might see iprope_in_check() check failed, drop when using the debug flow? (Choose two.)

Options :

A : Packet was dropped because of policy route misconfiguration.

B : Packet was dropped because of traffic shaping.

C : Trusted host list misconfiguration.

D : VIP or IP pool misconfiguration.

Answer: C,D

Question 2

Refer to the exhibit, which shows the output of a policy route table entry.Which type of policy route does the output show?

Options :

A : An ISDB route

B : A regular policy route

C : A regular policy route, which is associated with an active static route in the FIB

D : An SD-WAN rule

Answer: A

Question 3

Which statement about IKEv2 is true?

Options :

A : Both IKEv1 and IKEv2 share the feature of asymmetric authentication.

B : IKEv1 and IKEv2 have enough of the header format in common that both versions can run over the same UDP port.

C : IKEv1 and IKEv2 use same TCP port but run on different UDP ports.

D : IKEv1 and IKEv2 share the concept of phase1 and phase2

Answer: B

Question 4

Refer to the exhibit, which shows the output of a debug command.Which two statements about the output are true? (Choose two.)

Options :

A : The interlace is part of the OSPF backbone area.

B : There are a total of five OSPF routers attached to the vorz4 network segment

C : One of the neighbors has a router ID of 0.0.0.4.

D : In the network connected to port4, two OSPF routers are down.

Answer: A,D

Question 5

Refer to the exhibit, which shows the omitted output of a session table entry.Which two statements are true? (Choose two.)

Options :

A : The traffic has been tagged for VLAN 0000.

B : NP7 is handling offloading of this session.

C : The traffic matches Policy ID 1.

D : The session has been offloaded.

Answer: B,D