Question 1

How do you configure an in-band management IP address for the HPE Aruba Networking CX 4100i switch?

Options :

A : interface mgmt ip address 10.10.10.10/24 routing

B : interface vlan 1 ip address 10.10.10.10/24 routing

C : interface vlan 1 ip address 10.10.10.10/24

D : interface mgmt ip address 10.10.10.10/24

Answer: C

Question 2

What is modulated to transmit data over a multi-mode cable?

Options :

A : Radio

B : Light

C : Voltage

D : Pressure

Answer: B

Question 3

After testing a new HPE Aruba Networking 6200M switch deployment for a small office, you discovered that hosts in different VLANs cannot reach each other.What do you need to configure to enable connectivity between VLANs?

Options :

A : Configure an SVI for each VLAN.

B : Enable IP forwarding on the switch.

C : Trunk the VLANs to a Layer 2 switch.

D : Enable inter-VLAN bridging.

Answer: A

Question 4

A customer is about to connect a new HPE Aruba Networking CX 6200 switch using ports 1/1/47 and 1/1/48 to an existing HPE Aruba Networking 5406R switch in a VSF configuration. The VSF is already configured with the following settings:trunk 1/A24, 2/A24 trk2 lacp trk2 vlan tagged 100,200,300 vlan untagged 50 What needs to be configured on the new CX 6200 switch?

Options :

A : interface lag 27 lacp mode enable vlan trunk allowed 50,100,200,300 vlan trunk native untagged 50

B : interface lag 27 lacp mode enable vlan trunk allowed 50,100,200,300 vlan trunk native tagged 50

C : interface lag 27 lacp mode active vlan trunk allowed 100,200,300 vlan trunk native 50

D : interface lag 27 lacp mode active vlan trunk allowed 50,100,200,300 vlan trunk native 50

Answer: C

Question 5

A customer requires a network upgrade to replace their existing core switches. The new solution must support 100G speeds to the aggregation layer, with the ability to scale to a 12U chassis. Which HPE Aruba Networking CX switch model would you initially propose?

Options :

A : CX 6400

B : CX 10000

C : CX 9300

D : CX 8325

Answer: A