Question 1

What steps are part of the Key Management workflow when a wireless device is roaming from AP1 to AP2? (Select two.)

Options :

A : AP1 will cache the client-s information and send it to the Key Management service

B : The Key Management service receives from AirMatch a list of all AP2-s neighbors

C : The Key Management service receives a list of all AP1 s neighbors from AirMatch.

D : The Key Management service then generates R1 keys for AP2-s neighbors.

E : A client associates and authenticates with the AP2 after roaming from AP1

Answer: A,D

Question 2

With the Aruba CX 6100 48G switch with uplinks of 1/1/47 and 1/1/48. how do you automate the process of resuming the port operational state once a loop on a client port is cleared?

Options :

A : Configure int 1/1/1-1/1/52 loop-protect disable timer.

B : Configure global loop-protect disable timer.

C : Configure int 1/1/1-1/1/46 loop-protect re-enable-timer.

D : Configure global loop-protect re-enable-timer.

Answer: C

Question 3

Which feature supported by SNMPv3 provides an advantage over SNMPv2c?

Options :

A : Transport mapping

B : Community strings

C : GetBulk

D : Encryption

Answer: D

Question 4

In AOS 10. which session-based ACL below will only allow ping from any wired station to wireless clients but will not allow ping from wireless clients to wired stations"? The wired host ingress traffic arrives on a trusted port.

Options :

A : ip access-list session pingFromWired any user any permit

B : ip access-list session pingFromWired user any svc-icmp deny any any svc-icmp permit

C : ip access-list session pingFromWired any any svc-icmp permit user any svc-icmp deny

D : ip access-list session pingFromWired any any svc-icmp deny any user svc-icmp permit

Answer: D

Question 5

Which method is used to onboard a new UXI in an existing environment with 802 1X authentication? (The sensor has no cellular connection)

Options :

A : Use the UXI app on your smartphone and connect the UXI via Bluetooth

B : Use the Aruba installer app on your smartphone to scan the barcode

C : Connect the new UXI from an already installed one and adjust the initial configuration.

D : Use the CLI via the serial cable and adjust the initial configuration.

Answer: A