Question 1

What is true when describing HPE Aruba Networking VSX ISL to a new customer?

Options :

A : The ISL traffic is always tagged with EF QoS markings.

B : The traffic over the ISL is encapsulated as a GRE tunnel.

C : The ISL LAG automatically includes all configured VLANs.

D : The ISL LAG must allow all configured VLANs.

Answer: D

Question 2

You have run a script to configure a new VLAN on a CX switch, but are receiving a '404 - Not Found' HTTP response code. What do you need to do to resolve the issue?

Options :

A : Send a POST request to the /rest/v1/login resource.

B : Correct syntax error contained in the data payload.

C : Enable the switch REST API in read/write mode.

D : Specify the /rest/v1/system/vlan URI in the request.

Answer: D

Question 3

You are attempting to configure an interface, but you are seeing the error message below. What could explainthis?Access-1(config)# interface 1/1/1Invalid input: interface

Options :

A : The switch is in password recovery mode

B : The command must be run from the manager context

C : The switch is being managed by HPE Aruba Networking Central

D : Authorization is enabled for CLI commands

Answer: C

Question 4

With the given output from an HPE Aruba Networking CX 6300:Which statement about the output above is true?

Options :

A : The accepted AS paths are defined in the aspath-list.

B : The defined route-map is used in BGP with neighbor remote-as export.

C : The advertised AS paths are configured in an IP prefix-list.

D : The route-map with aspath-list intended for iBGP peers.

Answer: A

Question 5

Refer to the exhibit:According to the HPE Aruba Networking VSX best practices, what would need to be changed in the configuration?

Options :

A : Replace the CX6300 [1-2]/1/49 and [1-2]/1/50 ports with SFP56 connectivity.

B : Replace the CX8325 1/1/47 and 1/1/48 ports with SFP28 connectivity.

C : Replace the CX8300 [1-2]/1/49 and [1-2]/1/50 ports with QSFP28 connectivity.

Answer: B