Question 1

Exhibit

Referring to the exhibit, what must be included in the Route1 configuration when establishing an EBGP

session with the ISP?

Options :

A :

A local address must be specified.

B :

A local AS must be specified.

C :

The BGP session type internal must be specified.

D :

The BGP session type external must be specified.

Answer: A

Question 2

You are adding an IPv6 configuration to an Interface on a Junos device.

In this scenario, which statement is correct?

Options :

A :

The link local address must be manually configured within the fdO0::/8 prefix range.

B :

The link local address must be manually configured within the fe80::/10 prefix range.

C :

The link local address is automatically created using the MAC address within the fe80::'l0 prefix range.

D :

The link local address is automatically created using the MAC address within the fd00::/8 prefix range.

Answer: D

Question 3

Exhibit

You want the R1 and R3 routers to forward traffic destined to the 203.0.113.0/24 network through R2. Which

BGP attribute would you modify to satisfy this requirement?

Options :

A : community

B : origin

C : MED

D : local preference

Answer: C

Question 4

Exhibit

You are asked to configure OSPF between routers R1 and R2 using IPv6 addresses.

Which two tasks will accomplish your objective? (Choose two.)

Options :

A : Issue the sec protocols ospf area 0.0.0.0 interface ge-0/0/1.0 command.

B : Under the [edit routing-options] hierarchy, configure a 32-bit router ID.

C : issue the set protocols ospf3 area 0.0.0.0 interface ge-0/0/1.0 command.

D : Under the [edit routing-options] hierarchy, configure a 128-bit router ID.

Answer: A,D

Question 5

You are bringing a new network online with three MX Series devices enabled for STP. No root bridge priority

has been configured. Which statement is true in this scenario?

Options :

A : The device with the lowest MAC address will be elected as the root bridge.

B : The device with the highest MAC address will be elected as the root bridge.

C : The device with the lowest numerical lo0 IP address will be elected as the root bridge.

D : The device with the highest numerical lo0 IP address will be elected as The bridge.

Answer: A