Question 1

What are three phases of the Juniper Apstra data center life cycle? (Choose three.)

Options :

A : Configuration

B : Design

C : Installation

D : Operational phase

E : Deployment

Answer: B,D,E

Question 2

You want to gracefully take a device out of service to perform an OS upgrade. How would you accomplishthis task using Juniper Apstra?

Options :

A : After selecting the device in the Staged tab, you would select Deploy Mode then Upgrade.

B : After selecting the device in the Active tab, you would select Deploy Mode then Drain.

C : After selecting the device in the Dashboard tab, you would select Deploy Mode then Upgrade.

D : After selecting the device in the Staged tab, you would select Deploy Mode then Drain.

Answer: B

Question 3

You must enable ECMP load balance in your three-stage eBGP IP Clos fabric. In this scenario, which twofeatures are required? (Choose two.)

Options :

A : A load-balance policy applied to the forwarding table

B : multipath multiple-as applied to the BGP group

C : A load-balance policy applied to the BGP group

D : multihop applied to the BGP group

Answer: A,B

Question 4

What does VXLAN use to uniquely label and identify broadcast domains?

Options :

A : VLAN ID

B : Agent Circuit Identifier (ACI)

C : Virtual Network Identifier (VNI)

D : End System Identifier (ESI)

Answer: C

Question 5

What does clicking the indicated icon shown in the exhibit accomplish?

Options :

A : It refreshes the screen.

B : It fetches the discovered Link Layer Discovery Protocol (LLDP) data.

C : It erases the entire cable map to start over.

D : It changes the speed of existing links.

Answer: B