Question 1

A consultant is running the Foundation VM using desktop virtualization software. No nodes are discovered. What should the consultant verify first?

Options :

A : NAT

B : Host-only Adapter

C : Bridged Adapter

D : Internal Network

Answer: C

Question 2

An administrator recently added in 3 nodes to an existing 5 node cluster. While 1 node came with its own

block, theother 2 nodes where added to an existing share. After adding the nodes, the administrator sees that

the hardware tab displays the correct number of nodes, but incorrect position in the diagram tab.

What should the administrator do to resolve the issue?

Options :

A : Check the factory_config.json for all 3 nodes

B : SSH into CVM and perform genesis restart on each CVM

C : SSH into the CVMs and run genesis acropolis stop; cluster start

D : Check the factory_config. json for the two single nodes.

Answer: A

Question 3

A systems administrator configures a protection domain replication between two Nutanix clusters. After the

first successful replication , the administrator tests DR by clicking activate on the remote cluster.

While VMs are active on the remote cluster, the protection domain is marked as active on both clusters.

What steps are required to return both clusters to their original state?

Options :

A :

1. On the remote site, deactivate the Protection Domain using ncli

2. On the primary site, select theProtection Domain and dick migrate

B :

1. On the remote site, promote the Protection Domain

2. On the primary site, change the Protection Domain state from Decoupled to Disabled

3 Enable the original primary site as remote site

C :

1. On the prima7 site,suspend replications

2. On the remote site, deactivate the Protection Domain using ncli

3. On the remote site, migrate the protection domain back to the primary site

D :

1 On the remote site, restore the snapshots from the Protection Domain

2. On the remote site, select the Protection Domain and migrate to the primary site

Answer: C

Question 4

An administrator is supporting a business critical environment and deploys metro availability to achieve a zero

data loss configuration. The two clusters are connected by a 1GbE connection. A new workload is going to be

deployed to this cluster. This workload requires a sustained 150MB/S of write throughput and 20MB/s of read

throughput.

Which change must be made to deploy the workload successfully on this cluster?

Options :

A : The bandwidth must be increased tosupport this workload.

B : The workload must be configured to read at greater than 12.5MB/S.

C : The replication frequency must be less than 60 minutes.

D : Zero data loss nearsync must be used to support this workload.

Answer: A

Question 5

An administrator inherits a new Nutanix environment and logs in to a CVM to check the network configuration. The configuration is as follows:

Which action should the administrator take to improve network performance?

Options :

A : Configure VLAN tagging both on br0 and br1 and their physical interfaces.

B : Add eth0 and eth1 to the br0-up bond

C : Configure balance-sib or balance-tcp mode for br0-up if switch configuration allows

D : Remove one 10 Gbs interface from br0-up to make sure all 10 Gbs can be used.

Answer: C