Question 1

You have to disable a switch that is connected to a port on your FAS2750. You notice that the LIFs that are associated with this port are migrated to a port that is not expected. In this scenario, what would cause this behavior?

Options :

A : The network port is configured incorrectly.

B : The broadcast domain is configured incorrectly.

C : There are no online ports within the same failover group.

D : The network failover port is not licensed.

Answer: B

Question 2

Which two switch operating systems are supported on ONTAP cluster switches?(Choose two.)

Options :

A : Brocade FOS

B : Cisco NX-OS

C : Cisco IOS

D : Broadcom EFOS

Answer: B,D

Question 3

You were dispatched to install a cluster made up of FAS8060 and FAS8080 controllers. There are three FAS8060 controllers and three FAS8080 controllers. Which solution would provide the largest possible cluster?

Options :

A : a cluster made up of two nodes

B : a cluster made up of four nodes

C : a cluster made up of five nodes

D : a cluster made up of six nodes

Answer: D

Question 4

You create a new CIFS data LIF with the default failover group. In this scenario, where will the new LIF fail over if the node that owns the new LIF panics?

Options :

A : to any port in the cluster that is operationally up

B : to any port in the cluster that is administratively up

C : to any available port in the same subnet

D : to any available port listed in the broadcast domain

Answer: D

Question 5

After updating BES-53248 cluster switches, which two commands verify a healthy cluster? (Choose two.)

Options :

A : network port show -ipspace Cluster

B : network interface show -vserver Cluster

C : network device-discovery show -protocol cdp

D : network interface show -vserver Cluster -fields auto-revert

Answer: A,B