Question 1

You have recently discovered that NetApp ONTAP Cloud Manager is not sending AutoSupport messages to NetApp. In this scenario, what would solve this Issue?

Options :

A : Verify that your AWScredentials are correctly added to Cloud Manager.

B : Verify that your NetApp Support site credentials are correctly added to Cloud Manager.

C : Verify that your data LIFs allow traffic to mysupport .netapp.com on port 443.

D : Verify that the inbound and outbound rules allow AutoSupport on port 80.

Answer: C

Question 2

An administrator receives the following error message:

What are two causes for this error? (Choose two.)

Options :

A : There Is excessive SSD load causing the wear leveling to become unbalanced.

B : A disk is falling.

C : There is excessive SATA HDD load.

D : An SSD disk is performing garbage collection to create a dense data layout.

Answer: A,C

Question 3

You have a customer complaining of long build times from their NetApp ONTAP-based datastores. They provided you packet traces from the controller and client. Analysis of these traces shows an average service response time of 1 ms. QoS outputconfirms the same. The client traces are reporting an average of 15 ms in the same time period. In this situation, what would be your next step?

Options :

A : The cluster is responding slowly and requires further investigation using performance archives.

B : The client that reports high latency should be investigated.

C : The cluster interconnects should be investigated.

D : A sync core should be triggered.

Answer: B

Question 4

After a motherboard replacement on a NetApp AFF A300 in a SAN environment, the customer states that ports 0e and 0f are unable toconnect to the fabric. The ports report "offline". What would you examine first to troubleshoot the issue?

Options :

A : vserver fcp wwpn-alias show command output

B : system node hardware unified-connect show command output

C : storage port show command output

D : vserver fcp interface show command output

Answer: C

Question 5

Your customer calls you because one application is not able to access a NetApp ONTAP S3 bucket. While reviewing the EMS log on the cluster, you see the following message:

The same credentials work in another application. In this scenario, what would cause this problem?

Options :

A : The application is trying to log in as an anonymous user.

B : The application is using v2 signatures.

C : The application is using v4 signatures.

D : The application is trying to access using the HTTP protocol.

Answer: A