Question 1

You have configured FortiSASE Secure Private Access (SPA) deployment. Which statement is true about traffic flows? (Choose two answers)

Options :

A : When using SD-WAN private access, traffic goes from an endpoint directly to an SPA hub.

B : When using zero trust network access, traffic goes from an endpoint to a FortiSASE POP, and then to aZTNA access proxy.

C : When using zero trust network access (ZTNA) traffic goes from an endpoint directly to a ZTNA accessproxy.

D : When using SD-WAN private access, traffic goes from an endpoint to a FortiSASE POP, and then to anSPA hub.

Answer: C,D

Question 2

Refer to the exhibit.Which two statements about the onboarding process shown in the exhibit are true? (Choose two answers)

Options :

A : The user must manually select which FortiSASE components to install during the FortiClient setup.

B : Depending on the installer used, the invitation code step may be skipped.

C : The invitation code must always be entered manually after installing FortiClient.

D : This is an email from the FortiSASE platform to an end user.

Answer: B,D

Question 3

Refer to the exhibits.A FortiSASE administrator is trying to configure FortiSASE as a spoke to a FortiGate hub. The tunnel is up tothe FortiGale hub. However, the administrator is not able to ping the webserver hosted behind the FortiGatehub.Based on the output, what is the reason for the ping failures?

Options :

A : The Secure Private Access (SPA) policy needs to allow PING service

B : Quick mode selectors are restricting the subnet.

C : The BGP route is not received.

D : Network address translation (NAT) is not enabled on the spoke-to-hub policy.

Answer: B

Question 4

Refer to the exhibits.Jumpbox and Windows-AD are endpoints from the same remote location. Jumpbox can access the internet through FortiSASE, while Windows-AD can no longer access the internet. Based on the information in the exhibits, which reason explains the outage on Windows-AD? (Choose one answer)

Options :

A : The device security posture for Windows-AD has changed.

B : The FortiClient version installed on Windows-AD does not match the expected version on FortiSASE.

C : Windows-AD is excluded from FortiSASE management.

D : The remote VPN user on Windows-AD no longer matches any VPN policy.

Answer: A

Question 5

Which policy type is used to control traffic between the FortiClient endpoint to FortiSASE for secure internet access?

Options :

A : VPN policy

B : thin edge policy

C : private access policy

D : secure web gateway (SWG) policy

Answer: D