Question 1

Which component should be installed on the Vault if Distributed Vaults are used with PSM?

Options :

A : RabbitMQ

B : Disaster Recovery

C : Remote Control Client

D : Distributed Vault Server

Answer: A

Question 2

How should you configure PSM for SSH to support load balancing?

Options :

A : by using a network load balancer

B : in PVWA > Options > PSM for SSH Proxy > Servers

C : in PVWA > Options > PSM for SSH Proxy > Servers > VIP

D : by editing sshd.config on the all the PSM for SSH servers

Answer: A

Question 3

Which file would you modify to configure the vault to send SNMP traps to your monitoring solution?

Options :

A : dbparm.ini

B : paragent.ini

C : ENEConf.ini

D : padr.ini

Answer: B

Question 4

What is a step to enable NTP synchronization on a stand-alone Vault?

Options :

A : Run Powershell and add the NTP module.

B : Restart the organization-s NTP servers.

C : Edit dbparm.ini and add a Firewall rule for the NTP address.

D : Restart the Vault Event Notification Engine service.

Answer: C

Question 5

To enable LDAP over SSL for a Vault when DNS lookups are blocked, which step must be completed?

Options :

A : Add the FQDN & IP details for each LDAP host into the local hosts file of the Vault server.

B : Configure an AllowNonStandardFWAddresses rule in DBParm.ini on the Vault to allow outbound TCP 53 to the organization’s DNS servers.

C : Ensure LDAP hosts added to the directory mapping configuration are defined using only IP addresses.

D : Set the ReferralsDNSLookup parameter value to “No” in the directory configuration.

Answer: A